No USB drive when using Rescue Media Creator
Using ATI 2013 6514 Rescue Media Builder after a clean install I only get options for CD/DVD drive and ISO image even though the USB flash drive is recognized in the backup/recovery part of the program.
I have had no issues with ATI 10/11 in the past, not sure why now.
Thanks in advance...Dave

- Log in to post comments

So, ATI does not like SanDisk? I tried with a Kingston and it worked fine ,both same size, both formatted with the same tool ???
- Log in to post comments

I didn't say that. It could be that SanDisk doesn't like ATI. Many strange interactions can occur in Windows.
Is that one of the SanDisk drives that includes on-board utilities or a special partition?
How is it formatted, NTFS or FAT32?
- Log in to post comments

It had a folder of documentation but nothing that autoloaded, formatted it FAT32 with HP tool.
- Log in to post comments

I have same problem with it not recognizing a Toshiba Canvio Basics 1T usb hard drive. Formatted as FAT32 as required.
Does not show up on available drive options, just show ISO and CD. Not usb devices.
- Log in to post comments

If you are using this disk for storage of backups, the FAT32 file system will split the tib files at 4GB each.
You need a NTFS file system to limit the backup to only one large file.
How are you connected. Try using a USB2 cable or connector.
- Log in to post comments

The Toshiba 1T USB hard drive comes with it own cable.
See the link below to see specs.
http://www.bestbuy.com/site/toshiba-canvio-basics-1tb-external-usb-3-0-…
Every other piece of software can access the drive. Not problems there.
I just does not show up in the options.
Just for kick, I inserted two different USB memory sticks, both were recognized.
Also tried a different model Toshible USB drive, and it does not show up either.
- Log in to post comments