Skip to main content

Probs with build 6154 to 7119

Thread needs solution

I cannot get 7119 to work properly. Initially the installer failed at the end because the monitor was no properly installed and then somethingelse! however I messed about for a while including reinstalling/uninstalling using various methods. Thanks to be backups using TI I cold try various things, far too many scenarios to explain here albeit to say i was an IT consltant so bla bla. I have gone back to build 6154 and will not move from it. Still using XP!

0 Users found this helpful

Greetings,
Sorry to hear of your problems. The community would be happy to try and assist you resolve your issue, but we would need more detail about your problem and the steps you have tried to resolve it. If you'd like more help, reply with this information and we can try to move forward from there. Supplying the failed install log from one of your attemps might be a good place to start.

Hi Bin,
Your computer is like most of ours and has an accumulation of several installations.

In your trials, did you try using the Revo uniinstaller (either the pro or free version) in advanced mode?

Here is some additional info which may or may not relate.

http://forum.acronis.com/forum/26439

Also, before you boot after using Revo or other means, check these registry settings.

(!) After using Cleanup Utility, it is strongly recommended not to reboot the machine, go to Start -> Run -> regedit, and verify that there are no snapman*, fltsrv, tdrpman*, vidsflt*, timounter strings in the following keys:

HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Control\Class\{4D36E967-E325-11CE-BFC1-08002BE10318} -> UpperFilters and LowerFilters
HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Control\Class\{71A27CDD-812A-11D0-BEC7-08002BE2092F} -> UpperFilters and LowerFilters