Restoring from a USB Flash drive semi-automatically

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 1
Comments: 0

I have been using Acronis since version 9. Now I've come to the point where I would like to restore a computer semi-automatically. I searched for the answers here, but I guess the search terms I used are too commonly used here.

I can create a bootable Acronis USB, but what I would like to do is include my .tib file on the USB flash drive and have Acronis automatically run and restore the specific .tib file, without needing much input from me. I see there are command lines I could type in when creating the bootable USB, but I don't see the right mix to make it work. Is it even possible?

Thanks,
Rick

P.S. forgot to add, I'm using ATI 2010

Fri, 06/25/2010 - 18:15
0 Users found this helpful
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Forum Star
Posts: 45
Comments: 4263

This was possible using TI 10, 11, and Echo. The requirments are/were very strict -- to the point of being unusable for some users. I have not tested it with the later versions of TI to see if they have the same problems.

Fri, 06/25/2010 - 18:26