Runs Continously
Just upgraded from 2014 to 2015. I set up an Incremental backup of my C: drive. I set it to run at 12:30 AM on Monday and Thursday. Set it to do six incrementals before doing a full backup again. Set it to retain four full sets. I did not select continuous backup.
When it ran early this AM, it did a full backup then six incrementals then another full and six incrementals. It just runs continuously. Any ideas why it runs time after time?
Doug

- Log in to post comments

The problem was resolved by installing 6055. It would make a full backup, then immediately make an incremental followed by another incremental on and on. As soon as one backup ended, the next one would start. When I shut it down, I had 3 full backups and 18 incrementals all made in just over 8 hours. Going from 5539 to 6055 fixed it. It also did a lot to speed up the UI. Thanks for your response.
Doug
- Log in to post comments