Skip to main content

SATA 600 support

Thread needs solution

I changed my drives to SATA 600 as my motherboard supports this. The SATA 600 connectors are on a separate Marvell chipset which appears in the config as a SCSI. When I tried to restore an image I was unable to do so as ATIH2010 did not detect the drives. The drives are detected when running under W7/64 but restoring the C drive means a reboot and at reboot the drives are not detected any more. The same thing happens when I try to run ATIH from the recovery CD. Anyone knows if this is a known issue and if it is solved in ATIH2012?

0 Users found this helpful

Most likely this is a Linux driver issue. You will have to purchase the Acronis Plus Pack to create a WinPE-based disk that can see your disks.