Is there a command line method of starting Try & Decide?
Rather than have to start the Acronis TrueImage UI program, wade through its menus, and finally get to where I can activate Try & Decide, is there a command line that I can use to immediately and easily start Try & Decide mode?

- Log in to post comments

(Didn't get a notice from this forum about the reply hence the late date of my response.)
Sorry, but I found no executable file under the %programdir%\Acronis folder that separately runs the Try&Decide feature. So, nope, there isn't a means to load it from the command line. I was hoping, however, that there would be a command-line parameter that could be used on the called to its executable(s) that would immediately navigate the user to the Try&Decide setup panel inside of ATI's user interface. It's a pain to have to first wait for the load of the UI and then navigate through the dialogs to get at the Try&Decide screen, so much so that I haven't yet bothered to get rid of Returnil Home (free). It is a hell of a lot more convenient to right-click on a tray icon to then kick into the virtualized mode.
- Log in to post comments