Skip to main content

TIH 2010 - clone disk copying partitions TWICE?

Thread needs solution

Hi,

I'm just using the Clone Disk function of TIH 2010 to copy my old 500Gb drive to a new 2TB drive. I went through all the steps, choosing the manual method just so I could see what the end result would be.

It created 20 steps on reboot, and after copying all the partitions across, then proceeded to start copying them a second time! Therefore it's currently on step 17 of 20 but for the last hour or so it has basically been re-copying the data across which it has already copied.

Did I do something wrong to cause this?

Thanks
Steven

0 Users found this helpful

Hello Steven,

Let me assist you.

When you clone a drive, Acronis should just copy/move the contents of a source drive to a target one and resize partitions. So something went wrong in your case.

Could you please provide me with the exact sequence of actions that caused this issue?

We are looking forward to hearing back from you at your earliest convenience.

Thank you.