Try and Decide Says It Is Working But Doesn't - solved

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 7
Comments: 14

ATIH 2011 Plus Pack build 6942. I cloned a RAID 0 of 2 SATA 3 harddrives to a RAID 0 pair of SATA 3 SSDs (PYRO SE). LSI 9211 4i controller. Try and decide worked fine on the harddrive raid but not on the SSDs. It appears to be running and gives the time running notifications. Copied some files to my desktop and browsed a few websites. Discarded changes with a reboot and the files were there on the desktop and the browser history was there. No error messages of any type. Disconnected the SSD raid and then the harddrive raid try and decide would no longer work claiming it was a dynamic partition. Cloning set the proper offset on the SSDs and everything else works fine - backups and all other programs. Tried moving the secure zone and no luck. Is this a known problem? I searched the site and found issues with corrupt data using SSDs but not this problem. The harddrive raid 0 was left running for storage of large data files - two raid 0 drives. Backups are made to a single internal 2TB drive. Any suggestions or workarounds would be appreciated.

Sat, 04/14/2012 - 06:03
0 Users found this helpful
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Forum Star
Posts: 24
Comments: 3268

Hello Edward,

Thank you for finding time to open a thread regarding this issue.

From what I can see, you've marked the thread as solved. Do you mind providing us with the information on what should a User pay attention to when encounter such an issue? I'm sure others who might find this thread via KB search might use any useful tip you could share with us.

Thank you!

Mon, 04/16/2012 - 12:37