Very unclear explainations...

I am concerned (explained in another post) why a backup runs after each restoration, attaching itself to a former full stand alone set up as pictured. Backups must run from a preset task and yet not task are setup.

Reading the manual, although each item is explained, the effect(s) of their use is unclear. I would hope that defaults would not cause an automatic backup upon restoration.

I attached pics of my setup... full stand alone. The program was run from inside windows 8.1

From another thread, the suggestion was made to disconnect the external USB drive to short circuit a backup from beginning and I guess I could disconnect after completion and just before bios posting.

I noticed that two of my backups have a checkmark (back up completed successfully, but the second one does not. Perhaps this one is waiting for some incremental backup and desires to complete. I could not see any documentation of why the others have a check and it has an arrow pointing to the destination.

Its like that one is waiting for further action and yet its task parameters are no different than the others and that backup, a stand alone was completed successfully.

Sorry to bother, this problem seems to be a bug.