Skip to main content

Windows 10 32 bit and TI 2013

Thread needs solution

Acronis TI 2013 build 6514. Does Acronis 2103 work with Windows 10? I was using it with Windows 7 32 bit Pro on one of my computers, and upgraded to Win 10. Did not do a clean install of all software, but just let Win 10 replace Win 7. Many TI shortcuts were present in the new start menu, as in tools and utilities, but not one to activate the TI program in order to make a back-up image. Like is the case in my attached capture of my Win 7 computer. Unless I goofed and didn't see it? So I uninstalled the TI program before trying any other TI options. Probably a mistake. Also, I'm fine with using the boot disk for back-up and restore if necessary.
Thanks.

Attachment Size
capture.jpg 16.05 KB
0 Users found this helpful

I have done the same thing and I had no issues with the upgrade to W10 and I have run TI2013 and it created and validated a backup OK what I have not done is to do a restore - not had the need to do so at the moment.

Acronis' official position is that only TI 2015 and 2016 are compatible and supported on Windows 10. YMMV at your own risk.

Well 2014 seems to work just fine I have done backup and restore Win7, 8, 8.1 and 10 so one has to think until there is a verifiable explanation that it may just be FUD from Acronis to get everyone to upgrade. Time will tell...

There are some reports here of folks who have had issues with 2014 and Win 10. As I said YMMV. If you need support for a recovery Acronis may not help.