Migrate Easy - Cloning Problems - Target & Origin Drives
Decided to try Migrate Easy yesterday to clone my current hard drive in my little OQO 02 mini laptop/tablet to a new SSD.
Cloning process was going OK until about 70% complete when I noticed an error message. Looked away briefly as I grabbed my pen to make notes about message. Then when I looked at screen again I saw it said 100% complete, so, figured that process had gone OK after all.
So, put the new SSD in the OQO and tried to boot up into Windows7.
After seeing the OQO spalsh screen I get a black screen with white text that includes message:
PXE-E61
media test failure
check cable
No bootable device available
R - Reboot
S - Setup
Per message I re-inserted drive ribbon cable and tried again. Same message.
So, decided to put back original hard drive so that I could try re-doing drive cloning process. However, I get same error message as with the new SSD as noted above.
Any suggestions as to being able to boot up with original hard drive again?
Assuming I can get booted back to Windows, should I try Migrate Easy again or use True Image to clone hard drive?
Thanks for any help!!!
Mark

- Log in to post comments

Thank you, Colin for all your input....appreciate it!
Meanwhile, I'm embarrassed to say that I screwed up the part about reinstalling my original hard drive...I put in the drive backwards...after turning it around it boots up OK..
So, tonight I plan on trying to clone the drive again....hopefully, won't get error message this time.....
Thanks,
Mark
- Log in to post comments