Backup does not appear in version list
ATI 2013, Windows 7 Pro, 64 bit.
I just ran two backups. These were incrementals. They ran to completion, the files appear on the backup drive, the log contains a successful completion message. However, the "Versions:" information on the ATI interface shows the last backup as being the previous one, not today's. Furthermore, there are 8 versions on my disk (two chains of one full, three incrementals), but the Versions: information says 7 versions. If I attempt to recover a file, today's backup is not listed as a possible source. I've closed and reopened ATI, I've disconnected and reconnected the drive. I've even rebooted. ATI still doesn't seem to know about this last version. Well, that's not completely correct. If I tell ATI to backup again, it seems to know that the chain is complete (the setting calls for one full, three incermentals) and starts to write a full backup. Both backups I ran today are suffering from this problem.
What's going on here? How do I get ATI to recognize the most recent incremental?

- Log in to post comments

In 2013 it's found under "Browse for Backup". A rather graceless implementation - absolutely no indication anything is happening until the backup is added to the list of most recent. The disk does show seek action, but that's it for feedback. No progress indicator, nothing to show the command was accepted. But it did work.
- Log in to post comments