Skip to main content

PXE service

Thread needs solution

Hello All,

i have installed PXE service on acronis server. i have 2 ethernet adapters on it (one management and lab).

i have DHCP set for both networks. how can i set acronis to use only "lab" ethernet? currently, all machins who connected to "management" vlan are able to boot into acronis PXE (i want to exlude this VLAN from PXE service).

 

Thank You in advise!!!!

0 Users found this helpful
frestogaslorastaswastavewroviwroclolacorashibushurutraciwrubrishabenichikucrijorejenufrilomuwrigaslowrikejawrachosleratiswurelaseriprouobrunoviswosuthitribrepakotritopislivadrauibretisetewrapenuwrapi
Posts: 250
Comments: 7092

Hello Sharon,

Thank you for your posting! There are no special settings, you could configure your network using the following article and close the ports 67 and 68 in the management subnet, so that connection goes via lab subnet.

Thank you,