what happened from ati2016 to ati2017= WinPE-Media Builder (2017=no x86 support?
So today I received my ATI Home 2017 & have been comparing the Manuals..and found:
2016: page 118, Section 11.1.1 Acronis Media Builder:
"Acronis Media Builder supports both x86 and x64 WinPE 3.0, WinPE 4.0, and WinPE 5.0."
-----
2017: page 122, Section 11.1.1 Acronis Media Builder:
"Acronis Media Builder supports only x64 WinPE 3.0, WinPE 4.0, WinPE 5.0, and WinPE 10.0."
So is this a documentaion error, a return to a situation seen in earlier years or?


- Log in to post comments

I hadn't gotten to the point of poking around inside 2017 yet. But if I recall, this was an issue with v2015... I do recall that i made an Acronis winpe v6559 during the bumpy months when there was an issue with ati recognizing many USB 3.0 devices.
I knew that you would be THE MAN who could quickly determine if this was a documentation error or domething more...
as slways, your knowledge and reputation in this area are acknowledged!
bob
- Log in to post comments

WinPE media builder is built in. Ran the media creation part of the program and made a WinPE CD and WinPE flash drive.
- Log in to post comments

I see 32-bit pe components. Just installed the main version over the beta so now have to reboot before I can test. It might be that you can't create 32-bit PE on a 64-bit machine. I believe that even 2016 always defaults to 64-bit as well. I have not had an issue detecting any USB devices with default Linux media in years - it even detects USB 3.1 ethernet adapters on the Dell ultrabooks. I would give the Linux media a shot. Unless you have custom RAID enabled, the default bootable media is probably just fine.
Attachment | Size |
---|---|
385746-132775.jpg | 83.24 KB |
- Log in to post comments