Skip to main content

MustangPE plugin is now available for TI 2016

Thread needs solution

Sorry, my post was referring to your earlier reply, shown as #35

robert-abg wrote:

Once again, thx for all you do...refering to the above answer you kindly provided, pardon my ignorance in this matter.  I fo fully understsnd that you specified thst i should prepare both an x86 and x64 sets then use them on systems that are x86 or x64 as appropriate.

This leaves one final, but important question, when preparing these two variants, do they need to be created on pcs belonging to the x86 and x64 variants.  Put another way, can i prepare, for example, x64 and separate x86 versions on the same pc, just selecting the appropriate options.  Or must i CREATE ( versus later boot on...) the x64 version on an x64 pc and CREATE the x32 on an x32 pc?

i hope u understand my wuestion.

thx sgain

bob

 

 

 

Bob,

You can create both 32 and 64 bit versions on the 64 bit system. You will need to download separate programs for the 32 bit and 64 bit versions from my website.

Hi Robert,

You can create the media on any 64-bit machine as it can run either or both the 32/64 bit tools... a 64-bit OS can be used to create both 32 and/or 64 bit WinPE using Mustangs PE builder.  Not sure if you can create 64-bit WinPE on a 32-bit only capable machine - haven't tried, I'm thinking not, as the 64-bit MustangPE builder is a 64-bit application and wouldnt' launch on a 32-bit only machine, but am not sure. 

The 64 bit version of MustangPE is 32 bit application and should run in a 32 bit OS.