Creating Deployment user name and password rejected.
What has been tried so far must be the simplest setup possible using Snap Deploy 5 (trial).
Two W7/64-bit laptops, one with Snap Deploy 5 installed, the other is the target machine.
A deployment has been created using a TIB image gathered fromt the target laptop.
A boot USB stick has been configured for booting so that the target machine is ready to accept the deployment.
The deployment Wizard goes through all the steps, then asks for a username and password.
Apart from the administrator and guest accounts on the deployment laptop, I am the only account and have administrator rights.
The folder location on the deplyment laptop that contains the TIB image is shared for R/W access for everyone.
Why are my account credentials being rejected?

- Log in to post comments

What is the make model of the system to receive the image - in particular to find the installed NIC type. The default deployment uses a Linux kernel which may not have have the latest Intecl Nic drivers embedded in it. There is a versoin 1666 beta that should address this, but I believe the trial version is only good with 1660. Send a PM to Ekaternia (support engineer) and see if the beta can be used with the license key... if it can, this may be the version needed.
- Log in to post comments

Thanks, appreciate your help. Will check tomorrow morning.
- Log in to post comments