Skip to main content

2011 gets stuck at 98%

Thread needs solution

I am using TI 2011 to clone my IDE hard drive to my new larger SATA one. Everything goes fine for a while, then it gets stuck in the copying process at 98%. Before that it says that it cannot read certain sectors and I have said to ignore them all. I left it at 98% for over 5 hours and nothing has happened. What do I do?

Windows 7 64-bit

0 Users found this helpful

Are both drives in your machine or is the new one external at the moment?

Have you run chkdsk /r on your original drive?

Assuming you did not select the option to delete the contents of your original drive after cloning, you could just cancel TI from running, close Windows down and switch the machine off, then remove the new drive whilst you run chkdsk.

Did you start the clone in Windows or directly from the rescue CD?