Standalone TIH 2011 cannot see Network share for backup, but can see it for recovery

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 2
Comments: 3

Hi, I have the latest build 6857. I used a rescue disk to try and create a backup image. When I click the network item it cannot see any pc's on my network. However, if I try to recover an older archive, it sees the network fine. I confirmed the network settings and also tried using a fixed IP without success. Any suggestions? I like to use the standalone disc since it seems to backup faster.

Thanks!

Fri, 06/10/2011 - 17:13
0 Users found this helpful
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 2
Comments: 3

SOLVED! Just have to be patient. The network names resolution takes time so it didn't appear right away. Once the network discovery took place all the pc's showed up.

Sat, 06/11/2011 - 22:37