Skip to main content

Acronis won't install

Thread needs solution

I just purchased Backup and Recover 11 and as soon as I type in my key and goto install I get this

Code: 024182785
Line tag: 0x2289665869721eb7
Message: An internal error has occurred.

0 Users found this helpful

Hello Eric,

Thank you for your post. I will do my best to help you.

Could you get back to me with a screenshot of the error and could you send me a private message with your serial number so that I can check it in our database.

This information will help us localize the issue.

In case you need immediate assistance you can always contact our Support team directly.

Please let me know if you have additional questions.

Thank you.

Hi Eric

Please check the downloaded file size you have to ensure the installer has downloaded ok, I’ve had a customer that got a corrupted installer file and after they re-downloaded the software it fixed this issue.

ABR11A_17311_en-US.exe = 1,274,285,896 bytes (1.18GB)
ABR11A_17318_en-US.exe = 1,268,848,136 bytes (1.18GB)

Also as per above there is also a new build ABR11 Build 17318 that might be of interest as well.

Seems I'm running into the same snag.

Registered for a trial and I've tried the web installer and the full installer and I get the same error both times:

Code: 024182785
Line tag: 0x2289665869721eb7
Message: An internal error has occurred.

This error pops up immediately after component selection, before anything gets installed). For what it's worth - the license server installs without a flaw.

The OS is SBS 2011, the installation is attempted with the following files:

ABR11A_trial_en-US.exe - 1,18 GB (1.268.848.136 bytes)
ABR11A_web_en-US.exe - 7,59 MB (7.966.512 bytes)

Both end up with the same error.

D.

Hi Damirc and Eric

It might be best to contact support about this to get the issue logged with them, I’ve had a customer that had a similar issue with what from memory I believe was during the install of the Management server (could have been management console).

We found if you extract the MSI file and install this component using the extracted MSI file all went through ok, the customer was then able to re-load the ABR11 installer and continue the install as normal.

I’m not too sure if you have had a previous version of ABR10 installed or what is causing this issue but logging it with support would be best so they can look into it and collect the required logs to get it fixed in the next build. I have only seen it with 1-2 of our customers so it’s not common that I know of but something is obviously not working as it should and needs to be looked into but support will need to collect the logs so if you don’t mind providing this to them it could help others in the future.

Would be interested to see if this method above helps you out.