Cloning failed custom as is cloning after first partition.
I used clone disk, custom, as is. I have 5 partitions on my hard drive and I am trying to make an exact copy on to an 80 gb hardrive. I am putting my source 2.5 drive in the laptop and booting by cd and the destination drive is through usb. It was taking several hours and I let it go all night and when I woke up, it said something like cloning failed but when I checked the first 29 gb partition was successfull. Is there any way I can start where I left off or can I do one partition at a time until I have all five done? Or can I only do the complete hard drive at one time? Thanks for any info. Tyler
- Log in to post comments
TI 2012 is supported here http://forum.acronis.com/forums/acronis-true-image-home-discussions/acr…
- Log in to post comments
Have you tried doing a backup and then restoring instead of cloning?
Yes you can backup and restore individual parititions.
- Log in to post comments
I have tried that also. I tried partition mode and disk mode. When trying disk mode it starts and then immediatly fails. I havn't tried just doing one partition.
- Log in to post comments
Tyler,
You should consider checking your source disk for disk errors. From a command prompt
CKHKDSK C: /R
If you have no current backups, consider using the bootable medial CD and use it to make your backups until you find a solution.
- Log in to post comments