Invisible backup in Windows
Hello !
I create a disk image of my hard drive with a bootable CD of Acronis True Image 2016. This work runs smoothly and normally have validated. Then, when I launch windows, the image created is invisible in windows and it is yet present by looking at the number of bytes occupying the partition. I regularly use this software without problem for several years. I'm currently on windows 10. I have never encountered this problem before.
I installed the software Acronis True Image on my hard drive but I only use the bootable CD that I created from the software. Can you advise me so that I can again see my backups in the windows tree ?
Thanks a lot
Best regards
JP


- Anmelden, um Kommentare verfassen zu können

Hello Steve,
Thanks a lot. I'll test your advice. However, I have made no change in my computer's configuration or in my Acronis usage patterns. Usually, I found the backup created in the forlder selected after booting directly on the CD. But the transition to Windows10 was able to change my configuration.....
I'turn off the Windows Fast Start and test a new backup as soon as I have some time and would not fail to inform you.
Best regards
- Anmelden, um Kommentare verfassen zu können

Hello Steve,
I tested your advice and I managed to make a new backup.
Thanks a lot
Best regards
Jean-Paul
- Anmelden, um Kommentare verfassen zu können

Jean-Paul, thanks for your feedback, glad all is OK.
- Anmelden, um Kommentare verfassen zu können

Steve, thank you for the interesting observation. I have submitted a change request for automatic detection of Windows hibernation mode by Acronis bootable environment to prevent the issue that Jean-Paul has faced in the future.
Regards,
Slava
- Anmelden, um Kommentare verfassen zu können

Slava, that is good news as we have seen this a few times in the forums, though none very recently that I can recollect.
- Anmelden, um Kommentare verfassen zu können