Long merges two volumes! What to do? ( Долго объединяет два тома! Что делать?)
Hello. I have a 1 TB hard drive, it was divided into two volumes (E - 31GB, empty - formatted in NTFS) and (D - 900GB and it is 893GB filled with information. And also in NTFS) Both volumes are inactive and not bootable!
The upper progress bar of the operation is constantly changing, about every half hour - then a little forward,
then back a little (look at the pictures)! And so for several hours!
What's happening? Is this a failure or should you continue to wait? And how long do you have to wait?
On some forums, they wrote that they had waited 5 days and still had to cancel the operation! I'm afraid that important information for me will disappear from the disk! How to be, tell me, please? :-(
Здравствуйте. У меня жёсткий диск на 1 ТБ, он был разделен на два тома (E - 31гб, пустой - отформатирован в NTFS) и (D - 900ГБ и он на 893ГБ заполнен информацией. И тоже в NTFS) Оба тома неактивные и не загрузочные!
Верхняя полоса прогресса операции постоянно меняется, примерно каждые полчаса - то вперёд немного, то назад немного (смотри на картинках)! И так уже несколько часов!
Что происходит? Это сбой или нужно и дальше ждать? И сколько нужно ждать?
На некоторых форумах писали, что ждали 5 суток и всё равно пришлось отменить операцию! Боюсь, что с диска пропадёт важная для меня информация! Как быть, подскажите, пожалуйста? :-(
Anhang | Größe |
---|---|
photo_2021-03-21_15-13-01.jpg | 105.77 KB |
photo_2021-03-21_16-23-251.jpg | 37.71 KB |
photo_2021-03-21_16-23-281.jpg | 66.33 KB |

- Anmelden, um Kommentare verfassen zu können

Hi! Sorry to know about your negative experience with our software! If you have time, we'd appreciate your sharing a feedback via this form https://www.acronis.com/support/feedback.html
We also recommend taking a full backup of the system before applying any changes to be on the safe side in case the operation goes wrong.
- Anmelden, um Kommentare verfassen zu können