Can’t get a dual boot to work.
Using TI 10 I’m trying for an XP and Win7 dual boot HD to work to no avail. 1st I took a drive and partitioned the 1st 100g into 2 partitions, #1 and #2, each aprox 50G. I then took a new image of XP and put it into partition #2 where it booted and worked fine. Next was Win7 TI turn and installed it into partition #1. Before trying it I installed Win7 install disk and it indicated it made a repair, at which time I restarted and WASN’T given the choice of any startup OS, it just went straight to Win7, which also works fine.
Should this work as a dual boot setup and how many hoops are necessary to jump through? I’m not a geek so don’t understand MBRs’ etc. Please KISS so your grandparents can understand the solution as I’m probably older than that AND THICK. TIA

- Anmelden, um Kommentare verfassen zu können