Cloning Multi Partition HD with TI 2009

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Beiträge: 2
Kommentare: 1

I would like to clone a 320GB HD w/ three partitions onto a 1TB HD using TI 2009. I have created three partitions on the 1TB HD, but I do not seem to be able to select more than one partition on the source HD for cloning .. nor can I specify which partition it is to go into in the new 1TB HD. Any suggestions would be appreciated.
--
John
Knoxville TN

Sa, 11/13/2010 - 02:11
0 Users found this helpful
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Forum Star
Beiträge: 45
Kommentare: 4263

TI will only clone an entire drive (all partitions). You should be able to control the sizes of the partitions as part of the procedure. Any existing partitions on the target drive will be deleted.

If you need more control than that, consider creating a backup and then restoring it to the other drive.

Sa, 11/13/2010 - 02:39
  • Anmelden, um Kommentare verfassen zu können