Rotating two or more drives for backup in ATI 2015
I would like to set up one backup job that writes to disk A and another job that writes to disk B, then connect disk A for a week, and swap it for disk B the next week, and so on. The job corresponding to the disk that isn't attached fails, as expected. Is there any way to prevent the job corresponding to the disk that's not connected from trying to run? A simple checkbox saying something to the effect "Start only when disk is attached." allowed this in ATI 2014. Is there a similar way to accomplish this in ATI 2015?

- Anmelden, um Kommentare verfassen zu können

This extract from my guides may help.
AGH-3. 64634: Hints to help using 2 different target disks for TrueImage backups. New
- Anmelden, um Kommentare verfassen zu können


Ich habe exakt die Anleitung https://forum.acronis.com/forum/64634 befolgt. Das Ganze funktioniert jedoch nicht korrekt (zumindest bei mir).
Um beim Beispiel aus der Anleitung zu bleiben: schließt man die falsche „Farbe“ an – z. B. „blaue Disk“ und führt „roten Task“ aus, endet das nicht in einem kompletten Fehler, sondern es wird sogar der Zielordner (Unterordner je Rechner sind jeweils angelegt) des „roten Task“ zusätzlich auf der „blauen Disk“ angelegt!!!
-> siehe https://forum.acronis.com/forum/73358 (vor allem Testbericht #5 Fri, 2014-11-21 09:13 inklusive Protokolle).
- Anmelden, um Kommentare verfassen zu können