Bootable ISO, build 44421: no Network card detected
I try to run a backup from a bootable ISO ( AcronisBackupWS_11.7_44421_en-EU.iso) on an USB stick, but Acronis doesn't detect the network card for saving the backup on a different computer.
It's a brand new Lenovo X260 with an Intel I219-V Ethernet controller (according to spec sheet). Attached the system report. Any advice would be great !!
Attachment | Size |
---|---|
sysinfooutput.zip | 738 KB |

- Log in to post comments

Thank you Ekaterina,
I already tried the troubleshooting steps, without success, and will check the WinPE. I have read by chance a thread about Snap Deploy: they complain about the same network card; the conclusion was to wait for the next product release, which will support the Intel I219 card, but I'm not sure if this also applies to Acronis backup.
Best regards
- Log in to post comments

Hello Freddy,
Update on the thread: We've developed a custom build with the fix for this issue. If the issue still persists, please send me PM and I'll provide you with this build. Or you can wait a little bit, we're about to release an Update 1, which will also contain the fix.
Thank you,
- Log in to post comments