Skip to main content

Acronis Disk Director 11 advance

Thread needs solution

bootable media is not detecting any hard drives using the windows PE Is there a way to fix this?

0 Users found this helpful

That's most odd, what OS are you using and which version of WAIK?

Does the Linux version find the drives?

Im using windows vista ultimate 64 bit and vertion 3.0 of WALK

The Linux vertion is only finding them as single drives but not as one drive in RAID 0

the windows pe is only finding them as single drives if i changed in bios from raid to ahci mode

in safe mode it crashes

I also tryed with the motherboard RAID Drivers this didn't work

I also used WALK 2.0 this was giving the same resault

I then added a load of default Windows drivers (50+ drivers) to the acronis boot build (with WALK 2.0) as well as the RAID drivers This seemed to have worked as the drives as now showing as they do in windows

I'm right? DD11 Advanced is an Office Version, not for Home users?

DD11 Advanced Workstation and Server will install on XP, Vista and W7 systems, so home users could find a use for DD11 Advanced.

Note - I'm not sure if Server version will install on XP, it does on Windows 7 64 bit ultimate.

If you run a Server software then you would need the Server version as the Workstation licence won't allow it to be installed.

The two main differences between Advanced and Home (at this moment) is that it contains the disk editor and can access a networked or VM machine via remote log on.