Acronis Disk Director 11 advance
bootable media is not detecting any hard drives using the windows PE Is there a way to fix this?

- Se connecter pour poster des commentaires

Im using windows vista ultimate 64 bit and vertion 3.0 of WALK
The Linux vertion is only finding them as single drives but not as one drive in RAID 0
the windows pe is only finding them as single drives if i changed in bios from raid to ahci mode
in safe mode it crashes
I also tryed with the motherboard RAID Drivers this didn't work
I also used WALK 2.0 this was giving the same resault
I then added a load of default Windows drivers (50+ drivers) to the acronis boot build (with WALK 2.0) as well as the RAID drivers This seemed to have worked as the drives as now showing as they do in windows
- Se connecter pour poster des commentaires

I'm right? DD11 Advanced is an Office Version, not for Home users?
- Se connecter pour poster des commentaires

DD11 Advanced Workstation and Server will install on XP, Vista and W7 systems, so home users could find a use for DD11 Advanced.
Note - I'm not sure if Server version will install on XP, it does on Windows 7 64 bit ultimate.
If you run a Server software then you would need the Server version as the Workstation licence won't allow it to be installed.
The two main differences between Advanced and Home (at this moment) is that it contains the disk editor and can access a networked or VM machine via remote log on.
- Se connecter pour poster des commentaires