Can Connect to PXE Server but not the Deploy Server
Hi,
I am using Snap Deploy 3. I was able to install the agent and create a master image over the network. My problem occurs when I am trying to deploy the image.
I am able to boot my client machine just fine into the pxe server. I select Acronis Agent and then when it gives me 5 seconds to configure it, I hit ok. I then enter the Server IP Address under Deployment.
What is unusual in this screen is that there is no network card under the Network Adapters. In the user guide the picture shows eth0.
Once I hit OK it goes to the blue Acronis Snap Deploy Screen and at the bottom there is a message "Processing Please Wait". This is where the station stays. When I look at the Deploy Management Console, I can see that under 'Computers Available for Deployment" there is nothing. Just stays blank.
Any ideas?

- Log in to post comments
