SnapDeploy 3 hangs on "Loading please wait..." for dell optiplex 9020

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Posts: 1
Comments: 0

we just replace our pc with dell optiplex 9020 & when we try to clone using SnapDeploy 3 (build 3501) it just hang on "Loading please wait..." but our old PC that is Acer M970G it's ok.

can anyone help. Thanks

Regards,
joe

Wed, 12/04/2013 - 03:10
0 Users found this helpful
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Forum Member
Posts: 0
Comments: 69

Most likely this means that our Linux Based snap deploy agent does not have drivers for your new machine.
You can try to create winPE media and inject 32 bit drivers for your hardware into it. It should be able to boot fine.

Tue, 12/10/2013 - 18:44