backup/restore with BartPE TrueImage & Truecrypt...
Hi there,
I've been using BartPE built with TrueImage 11 library for a long time to backup, restore and resize whole partitions to NAS storage via Gigabit ethernet. It works great - a nearly ideal solution for me, until I tried it with a TrueCrypt volume... now I get "Error: no bootable partition found".
I was able to backup a TrueCrypt 6.2 encrypted volume with BartPE/TrueImage 11 successfully to NAS storage (well, it verified OK at least). I was also able to do sector-by-sectore restore of the MBR & encrypted volume (with BartPE/TrueImage11) to the same physical drive in the same physical system. Acronis s/w said operation was completed successfully.
BUT after TrueCrypt prompts and appears to accept the decrypt password, I cannot boot successfully... TrueCrypt now reports "Error: No bootable partition found".
The physical disk was repartitioned, reimaged & then unpartitioned since it last worked. I wonder if the partition table on the destination drive needs to be exactly as it was before?
Unfortunately I only backed up the main NTFS Windows partition (but not the Lenovo recovery partition that was also on the disk)... I had intended to blow the recovery partition away later. I understand that I can't resize an encrypted partition without first unencrypting (so TrueImage restore can see & resize the file system, etc).
But now I'd sure be happy to be able to get my image to work again.
Any suggestions?
thanks,
Rob
ps: key learning so far -
- back up the whole disk, not just the encrypted volume,
- know that encrypted image can only be restored to drive with same heads/sectors/size (?), and
- try a full restore and boot up to make sure backup/restore of an encrypted volume works "end to end" before you have to depend on it...

- Log in to post comments