Universal Restore does not appear on rescue disk
I installed True Image 2010 (build 6,053) with plus pack and created a rescue disk. The Universal Restore check box does not appear when I do an image restore from the rescue disk. I made an image, upgraded the motherboard and need UR to reinstall the OS with new drivers. I saw the identical problem occured in Backup&Restore 10.

- Log in to post comments

The archive contains an "Active" primary partition. When I run Acronis Home in windows on another PC, the "Use Universal Restore" checkbox is displayed properly for this same archive. I remade the rescue CD from within the running software (the first was burned thru the start submenu selection) but still no UUR option on recovery.
- Log in to post comments

What happens if you use the same Rescue CD on this second PC where the UR option was available (from the software in Windows)?
- Log in to post comments

I used the same Rescue CD on this second PC where the UR option was available (from the software in Windows) and the Universal Restore option did NOT appear. So, the problem is in the Rescue CD. UR is the reason I updated from the previous verson.
- Log in to post comments

Ahh .... oh well ... I don't have any other ideas. Hopefully someone else will jump in here with suggestions.
- Log in to post comments

I created one rescue CD.
If I boot from this CD, the UR appears on one PC but not on another.
In both cases the .tib selected contains an active, primary system partition.
- Log in to post comments