unable to load a backup in ASZ
Hi
I download and install build 7046
AND NOW -->
when i boot on my CD rescue (do with true image home with 5029 or 7046) or with the boot CD download from the site,
if i try to see backup in Acronis Secure Zone to restore, i can't see it.
And if i try to backup it is the same problem, i can't choose acronis secure zone (GUI doesn't see it).
But if i boot normaly my PC and run Acronis true image home 7046, i can see in ASZ, and backup in it.
so I delete this zone and recreate it but the problem is again.
BUT BEFORE
with build 5029, i could see in ASZ in boot CD mode.
Thanks for your help
regards
(sorry for my english)

- Se connecter pour poster des commentaires

Bruno,
Can the Rescue CD see all your other drives and partitions?
- Se connecter pour poster des commentaires

Colin,
Yes i see all partition : execpt Acronis Secure Zone.
For exemple i see drive F:\ but not ASZ:\ --> And in fact F: and ASZ:\ are on the same physical disk.
tomorrow i try catch photo to explain my problem.
Regards
- Se connecter pour poster des commentaires

I join 2 jpg.
on the first, it is a capture when i try to backup with boot cdrom build 5029 --> we can see Acronis Secure zone
in the second jpg , i boot with the boot cdrom build 7046 --> we cann't see Acronis Secure zone.
Acronis Secure zone isn't supported with 7046 build?
Fichier attaché | Taille |
---|---|
36298-90397.jpg | 325.25 Ko |
36298-90400.jpg | 410.38 Ko |
- Se connecter pour poster des commentaires

in fact on this capture E: et ASZ: are on the same physical disk.
- Se connecter pour poster des commentaires

Bruno,
Is build 5029 a French build or an early beta build of 2010?
I assume the ASZ was created using build 5029.
Do you have the SAFE mode installed on the 7046 CD? If you do, can you see the SZ if you boot from that option?
- Se connecter pour poster des commentaires

Colin,
My 5029 is a french build.
ASZ was created with this build (5029 Fr) but, as this ASZ hadn't seen by 7046 build (download build), I dropped and recreated a new ASZ with 7046 build. But no effect, 5029 boot crdom continue to see the new ASZ AND 7046 boot cdrom don't see the ASZ.
In the 7046 (download version) i don't have a secure option (i think i will verify). I will check also if i have a secure option i the boot cdrom that i made from my TI installation.
I hope that i was clear in my explication.
- Se connecter pour poster des commentaires

OK thanks for your help!
I just created a boot cdrom with TI 7046 and i add this time the rescue option. And now when i boot on this with rescue option i see ASZ. (but i don't if i boot without this option)
Do you know if it is normal that i can't see ASZ with 7046 boot in normal mode
and i can see only with "recue mode"?
Thanks again.
- Se connecter pour poster des commentaires

Bruno,
The SAFE mode uses DOS type access to your drives via the BIOS, so it often happens that the Linux drivers can't access the system but the Safe mode can. This also alters between builds and the different language versions.
If you find that using the safe mode is too slow, then it might be possible to use the standard Linux version but with parameters added.
You could also either make a BartPE or Windows PE disk which uses Windows drivers and you then shouldn't have any problems at all.
- Se connecter pour poster des commentaires