Aller au contenu principal

Acronis clone isn't saving System Volume (Restore points)

Thread needs solution

Trying to use Acronis clone on a drive to clone entire drive to new same size drive. Goal is to use the new drive to run a restore on the new drive to test.

After full clone it acts as though System Volume Information (restore points) were not carried over. Are their settings to address this?

0 Users found this helpful

Which method of cloning are you using here and which version of Acronis True Image?

Please see KB 62304: Acronis True Image: Windows system restore points disappear after backup, recovery or disk cloning - which may be relevant here too.

I'm not very familiar with the Clone process so this comment may be nonsense, but are you excluding System Volume Information?  I believe that is where the Restore Point info lives.