[RESOLVED] Checking Vault (Process Never Finishes)

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Contributions: 1
Commentaires: 1

I have setup Centralized Vaults to use with any backups that I want to kick off. However when I go to create the backup plan and choose the centralized vault I want to use I get a window that says "Operation Progress" "Checking Vault...". I have tried letting this run but even after a couple of hours I come back and it is still running the vault check. I have only been using the product for about a week so I am guessing I have set something up incorrectly. When I set the back up to back up directly to the storage device that I also linked the vault to it works fine, but I would like to use the Centralized Vaults. Any direction would be great thanks.

Find the solution here.

mer 09/01/2013 - 16:02
0 Users found this helpful
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Contributions: 1
Commentaires: 1

After searching through keywords in the forums on "Checking Vault" I found several cases where this was an IPV6 issue on networks that are currently IPV4.
I used the following fix it tool from Microsoft to disable IVP6 on the server that the management server is loaded on:

http://support.microsoft.com/kb/929852

This corrected my issue. Not sure if this will help anyone else out but if you are still on IPV4 and not using IPV6 at all this did work.

mer 09/01/2013 - 16:37