Disk Director Home 11 Cloning Win 2000 Hard Drive

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Contributions: 2
Commentaires: 1

I'm trying to clone a Win 2000 Hard Drive using Disk Director Home 11. I've got the source and target disk plugged into a Win 7 system on which DDH11 is running. I've tried copying the NT ID and each time result is the same. Cloned disk does not boot up all the way, I get a Blue Screen with "STOP: 0X0000007b (0xeb82f84c, 0xc0000034, 0x00000000, 0x00000000) INACCESSIBLE_BOOT_DEVICE.

Any suggestions as to what I might be doing wrong?

mer 13/04/2011 - 16:55
0 Users found this helpful
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Contributions: 2
Commentaires: 1

Oh, I've got it. Problem was the size limitation inherent in Win 2K. Win 2K can only see 128GB. My new drive was 320GB and the clone was 320GB. If I clone without proportional sizing I'm ok. Win 2K only sees 128GB of the new drive, which for my purposes is ok for now.

mer 13/04/2011 - 18:36
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Forum Star
Contributions: 45
Commentaires: 4263

Have you enabled 48-bit LBA Support in Windows 2000? It may allow you to use the remaining space on the drive. See this Microsoft KB article.

jeu 14/04/2011 - 05:11