Cannot Deploy Image to Optilplex 380 with snap deploy

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Contributions: 3
Commentaires: 1

I cannot deploy and image with snap deploy to Dell Optiplex 380 with Snap Deploy when I load up the boot disk it does not see the nic card and then it just says processing and gets me nowhere.

Any Help would be greatly appreciated.

Thanks
Rich

mer 18/08/2010 - 12:51
0 Users found this helpful
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Forum Star
Contributions: 24
Commentaires: 3268

 Hello Rich, 

Welcome to our Forum. 

The issue caused by the lack of drivers and resolved by updating bootable components on the PXE. I will send you the instructions with links via Private message in a minute. 

Please note that this issue was already addressed in the Main Thread. Feel free to share your opinion, comments and questions regarding this question there!

Thank you!

mer 18/08/2010 - 15:02