Aller au contenu principal

Help... I broke Schedul2 Logging

Thread needs solution

I am running ATI 2017 build 8029 stand alone license (not NG).

I've been trying to figure out an issue I have in scheduling. In the process, I followed this https://kb.acronis.com/content/1859 and ran the Acronis Scheduler Manager command "set logflags support". Through the MVP log viewer, I saw that it was constantly throwing a lot of weird new stuff in the Schedul2 log so I then did "Set logflags 0", but now that seems to have turned off logging entirely.

Could someone please run the Acronis Scheduler Manager command "get logflags" and tell me what the right number is so I can get back my correct logs.

Thanks.

0 Users found this helpful

Bruno, I see the following on my system for 'get logflags'

inst=yes start=yes loc task=0-0 > get logflags
LogFlags: 0x10000 ( )
inst=yes start=yes loc task=0-0 >

Thanks, Steve. That's the bloke!

I figured out what all the bits were in the 16 bits of flags, but I could not figure out how to get to the Default setting. Little did I suspect it would be the 17th bit. All is now well.

Bruno, glad to hear all is well again.