Trial Version for True Image 2021 Question: backing up select hard drives
Maybe I'm missing something but just did my first backup for my PC and didn't see where it asks me which drives I want to backup/not backup. e.g. I have 2 drives: "C:" and "D:" and only want to backup "C:".
Regards,
Patrick


- Se connecter pour poster des commentaires

IanL-S wrote:It is not immediately obvious. To select the appropriate backup type Bourke click on the source icon - it is whole PC and this will bring up the option; you will need to select disks and poartitions
Thanks, but how do you change it after you've done a backup (say i want to add "D:" and didn't with the initial backup
- Se connecter pour poster des commentaires

Use the same method, click on the Source panel, then on Disks & Partitions, then select any additional items to include (or remove) from the backup selection.
- Se connecter pour poster des commentaires

Steve Smith wrote:Use the same method, click on the Source panel, then on Disks & Partitions, then select any additional items to include (or remove) from the backup selection.
Source panel? Where is that?
- Se connecter pour poster des commentaires

Patrick, the Source panel is the big square that says XEON under a picture of the monitor (left middle of right pane) . This image is used for an Entire PC backup.
- Se connecter pour poster des commentaires

BrunoC wrote:Patrick, the Source panel is the big square that says XEON under a picture of the monitor (left middle of right pane) . This image is used for an Entire PC backup.
understood, but when I click on it I dont have an option to change the backup (to select/deselect drives). Above, Steve Smith said "Use the same method, click on the Source panel, then on Disks & Partitions"
- Se connecter pour poster des commentaires

- Se connecter pour poster des commentaires

so....there's some sort of weird behavior with the trial version that wasn't allowing me to change the source configuration. Clicking on the source would not open or show "change source"
I actually had to uninstall the trial and then trial and reinstall for it to work.
- Se connecter pour poster des commentaires