2010 6023 dies after 85% plus non-stop setup ...

Hi,

I have Windows 7, i7-920 and 8 Gb RAM.

Still trying to get non-stop to work. At first it would crash out and not even start properly without locking up. Found no answers in Forums or Replies. Figured out that that first issue seems to be a compatability issues of 2010 with Windows 7. Switched Acronis.exe to be Compatible with Windows Vista and things started to work, I thought.

Set up non-stop for three hard drives, around 1.5 Tb total though half that in actual use. Non-stop will work for up to 85% on the initial partition imaging and, then, zap, boom, locks up and dies in any further processing. No error message. Just a ballon popup of Non-stop backup is turned off. This is the 2nd time I've tried using non-stop with same dead-end result. Because it takes about 8-10 hours to get to the point where non-stop dies and stops doing anything is why I am posting this message.

Ideas? Suggestions?

Thanks.

John H