Aller au contenu principal

Alignment when restoring an image from single ssd to RAID ssds

Thread needs solution

So I need to transfer my current os config from a single Corsair Force GT 120gb to a RAID setup with two of these drives. Does TrueImage 2013 handle alignment properly when restoring an image to a RAID?

0 Users found this helpful

Tom,
Please reveiew page 14 and the section on SSD alignment starting on page 149 of the 2013 user guide. Correct alignment and offset is supported in 2013, however, your configuration and the operating system may have other requirements such as the storage controller drivers needed to boot with the new disk configuration. Using the Universal Restore option with the proper storage controller drivers should allow you to migrate successfully.

Tom,
Please look at 'WinPE4 CD rescue How To' topic .
I did not succed to migrate my PC system (W7-64 bits SP1 Premium FRench version) from one SSD AHCI configuration to a twice SSD RAID 0 configuration.
P8Z77-V Deluxe Bios 1607 , i7-3770K@3.5, 16GB RAM, 2 x 240 GB GTX Neutron SSD Corsair , 2To Hitachi SATA IIII, USB , ATIH 2013 P+
Universal Restore does not work (Failure message).

Did you have some experience of this challenge to help me ?