ATI is not recognizing the origin-disc in the disk-clone operation
Hi all.
I am needingo to clone disk.
I recorded a bootable DVD (with downloaded iso file) and starting with Acronis True Image from it.
Initially all went well.
Regarding the CLONE operation I chose the Automatic mode, and when I went to set the source disk, I found the following table and could not go ahead.
Drive............................................................Capacity.........Model....................................................................Interface
Disk 2...........................................................8 Gb...............iswstripe...............................................................RAID
Disk3 - Unsuported.......................................931.5 Gb.......iswstripe................................................................RAID
Disk4.............................................................698.6 Gb.......ST9750422AS........................................................USB
Disk5.............................................................1.819 Tb........Seagate FA GoFlexDesk........................................USB
My goal is to clone the hard disk 3 to 4, and when I select disk 3 as source, the software (ATI) tells me that it can not copy a blank disc!
Why ATI is indicating disk 3 as unsupported?
Why ATI is considering disk 3 as empty?
Is there some setting that I have to do into notebook bios setup that modifies this scenario?
TIA
Marcos Nobre
- Se connecter pour poster des commentaires