Boot Failure
Hi,
Earlier tonight I began the cloning process to clone my data on my Toshiba hard drive, to my ADATA 256gb m.2 SSD. Everything was going well until when the program prompted me to restart the computer, which I did. Upon restarting I was greeted by a message telling me I had no boot device, and I could not boot.
I am now stuck with a non operational laptop. I thankfully had nothing important on it, it was a clean install of Windows. But now, it won't boot.
Please help!

- Se connecter pour poster des commentaires

Hi,
I am currently at school, but I can check these things when I get home. If this can help, my laptop is a HP Elitebook 840 g1 with Windows 7 Ultimate on it.
Thanks for your help!
- Se connecter pour poster des commentaires

Joe,
Can you put the old HDD back into the laptop and does it then boot OK?
FtrPilot
- Se connecter pour poster des commentaires

My laptop has a m.2 slot and a HDD slot. I'm keeping the HDD for mass storage, so it's still in at the same time as my SSD.
- Se connecter pour poster des commentaires

Joe,
Can you set your BIOS to boot from the HDD? I want to make sure the HDD is still OK. If so, I believe you have a way forward. I'll be online most of the evening and will await your response.
FtrPilot
- Se connecter pour poster des commentaires

Yes, I have done all of these. I contacted HP and they will be sending over recovery disks for free. They offered to send over a HDD but the disks will do.
I'll keep you posted
- Se connecter pour poster des commentaires