Cannot create WinPE bootable with Acronis plug-in.

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Contributions: 2
Commentaires: 3

Working with ATI Home 2011 with the PlusPack installed on top.

Following kb13643, I downloaded the PE3.0 iso and extracted it to a folder called winpe.
Directed the Acronis iso builder to various sections of this folder. ERROR MESSAGE:
"The selected folder does not contain the required files. The resulting image will not boot."

I downloaded PE 2.1 iso and extracted to a folder called pe21. Directing the iso builder to this folder results in the same error.

Now following kb13641, I burned the 3.0 iso. Made sure .NET 2.0 was part of system, and installed 6.0 parser. Then installed WAIK from the iso.
Ran copype x86 to c:\winpe (which I had emptied before this). Directing Acronis iso builder to this folder also results in the same error, even though there are boot files in there. Contents:
Folders: boot; efi; WinPE_FPS
Files: bootmgr; bootsect.exe; winpe.wim

Why is this so difficult?

mar 10/01/2012 - 06:23
0 Users found this helpful
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Forum Hero
Contributions: 88
Commentaires: 7700
mvp

Versuche diese Anleitung mal:

http://www.ehow.com/how_7710150_build-windows-pe.html

In Step7 "oscding" ist falsch. es sollte meiner Meinung "oscdimg" sein.

Fichier attaché Taille
88231-98968.gif 33.31 Ko
88231-98971.gif 28.51 Ko
88231-98974.gif 35.51 Ko
88231-98977.gif 38.27 Ko
mar 10/01/2012 - 12:08
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Contributions: 2
Commentaires: 3

Worked it out.
This will be successful if one installs the WAIK 3.0 (W7) first.

My problem from above stemmed from the fact that I pre-created the winpe folder; and to compound the mistake, named it winpe without the x86.
I didn't get the ISO sub-folder.
This is contrary to the copype script. YOU MUST NOT PRE-CREATE THE winpe FOLDER!
After invoking the Deployment Tools Command Prompt, run the command: copype x86 c:\winpex86 exactly like that.
(amd64 and ia64 are other architecture choices in place of x86.)

Now, when I point the Acronis WinPE ISO builder to c:\winpex86\ISO, it is very happy with that and continues. The rest is just default-accepting the "Next" boxes.

mar 10/01/2012 - 20:15