Aller au contenu principal

Clone of new notebook SSD fails

Thread needs solution

I cloned the 500GB original drive of my new notebook to an 120GB SSD, then installed the SSD -- it is wonderful. The original (and clone) had a restore partition. Because the SSD is much smaller, I shrank the restore partition on the SSD to near zero, then formatted the it.

Now, having built up the system software on the SSD, I want to clone it to another USB drive for backup. I always boot on the True Image CD to clone. I've never used any other True Image feature.

When I begin the clone of my SSD to a drive on a USB adapter (which I've used often with desktops) the clone ALWAYS fails. I believe the problem is the vestigal restore partition. I've tried two USB adapters and three separate hard drive targets. True Image always fails near the beginning of the clone.

If the problem is the tiny partition, I guess I can increase it with a partition program, but they are always risky.

Hope I don't have to start over after hours of software installations. And I DO want a full disk backup.

Any suggestions?

0 Users found this helpful

TrueImage provides two methods to create a duplicate disk. There is the clone option and the second capability is the backup and restore method.

1. Boot from the CD and perform a backup and be sure and checkmark the disk option as to what is being included in the backup. This will cause all partitions to be included in the backup. Store the backup (*.tib file) on an alternate disk or location.

---To create the 2nd or duplicate disk via the Backup/Restore method.
1. Install the new blank target disk in the computer in its intended boot location.
2. Boot from the CD and choose the Recovery/Restore mode.
3. Browse to the newly created backup file and select this file to be restored.
4. When selecting what contents of the backup is to be restored, checkmark the disk option so all partitions will be restored.
5. When selecting the target disk, also select the "Recover disk signature" option.
6. Shutdown.
7. Reboot with only the new disk installed. Disconnect any other usb drives, etc.
On first boot following the restore, you want Windows to see only the new drive.

Note: While restoring to a usb device sometimes works, you have a better likelihood of success if you have the target disk in its intended boot position. Since the ultimate target has to be booted inside the computer as a test anyway, putting it into the computer before restoring really does not add any extra work and is especially important if the computer happens to be a ThinkPad.

You may find some interesting reading via my gold/tan colored link in my signature below. A slightly different restore procedure can also be found by clicking the yellow link below and looking at index item #3-BB. This 3-BB may not match your hardware but the procedures are basically the same.