Creating a bootable rescue media USB drive
I think I must be missing something obvious.
I have two "fat32" formatted USB sticks. When I try to use the recovery media builder, I either end up with a drive that is not bootable (I get "non-system disk, press any key...") or a drive that might be bootable, but shows nothing on screen when it boots a laptop.
Does the USB drive have to be preformatted in a specific way to make it usable with the Recovery Media creator application? (This is using build 6868).
Thanks!
- Se connecter pour poster des commentaires
My problem (I think) was that I make my bootable disks using VMWare Fusion on my Mac. I erased the USB drive on the *mac side* and then popped it into Fusion to make the bootable disk -- that's what failed.
I tried a second time by only mounting/erasing the USB drive *within Fusion* -- and then redoing the bootable media run. The second time -- it worked.
- Steve
- Se connecter pour poster des commentaires