Disc Cloned XP wont pass onto user logon page
Hi everyone,
I've cloned a disc using disc clone of Acronis 9, however the clone does not pass onto the user logon page, but starts a never ending task (hdd reading). Cloned disc had multiple primary and extended partitions, where mbr was on a recovery partition (NTFS), carrying on with the OS boot on an extended partition (NTFS). Anyone got any idea on this situation? Could it be a hdd serial problem, and how can I solve it if so?
[ The disc I cloned had possible SMART issues, which later turned into an error -not booting. But at the time of cloning, it was just a warning. (Errors were on Start/Stop and Power Cycle counts) ]
Thanks for any help..
halukb
- Se connecter pour poster des commentaires
Stop using that drive! Don't use it until you're ready to make a full disk backup, as recommended by shadowsports. The more you use a failing drive, the more likely it will fail completely.
And, make a full disk backup, do not clone.
- Se connecter pour poster des commentaires