Help! Can't restore w ATI 10.0

Thread needs solution
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Beginner
Contributions: 2
Commentaires: 0

I created a complete new backup archive for my multi-partition disk 1 when I bought a new external hard drive a couple of months ago. Everything validated after creation; I have 17 files (mybackup1-17.tib). A week ago, my HDD registry suddenly crashed, and was unrecoverable, so I need to restore my system (including program files) from this fileset. However, when I use my restore disk to begin the restore process, I don't see partition images (as I recall seeing when I looked with the program's explore feature after making the file set), but instead the 17 individual files. I really need to get my system setup back from these backup files, as I have very few of my software setup CDs, most having been lost to flooding from Hurricane Ike a year ago. All help and suggestions greatly appreciated! -- Dave K.

sam 03/10/2009 - 19:46
0 Users found this helpful
truwrikodrorowrelupicugojestutroclulachosaswunuhospikigawakijosaswenomaruclojeueclikaspedrubewidebrisubrohutrurifruuagothunugekedrumucisiuobrobrecrupeslapuswosluprothethibakaslechurathikucli
Frequent Poster
Contributions: 2
Commentaires: 570

Not sure what exactly the issue is but the 17 files are likely your image backup, especially if the external is formatted FAT32 which has a maximum filesize of 4GB. This would mean the total archive is about 64-68GB.

If so, just select any one of the .tib files and TI will know that they are all part of the same image archive.

sam 03/10/2009 - 20:13