Aller au contenu principal

TI does not work after 2.1 update installed

Thread needs solution

Received notice of update. Downloaded/installed. TI will start but will not operate properly. Tried full backup of 203 GB and only 733 KB backed up. Program freezes and shuts down.

0 Users found this helpful

If you installed the current released version (build 7133) over an existing older build, you could have some problems created during the installation that need to be corrected. Some folks have reported problems when upgrading. Your best bet at this point is to remove the program using Add/Remove programs from control panel, and then run the Acronis True Image 2012 Cleanup Utility found here: http://kb.acronis.com/content/24545. Be sure to follow the directions carefully. After you have finished those steps, install ATIH 2012 build 7133.