Restore Failed Message, but Restore Seems to have Succeeded
I backed up a Lenovo R500 Drive successfully. Following the instructions in the manual I restored to a new hard drive.
I restored the two partitions (C drive and recovery partition and not the MBR)
The result was a message saying that the Restore Failed. However, the computer runs normally from the new drive.
I assume that only the recovery partition failed. When I run Acronis on the computer with the new disk in it, only the C drive partition shows. The Lenovo recovery partition is not there.
I can keep the old hard disk for the recovery partition, but it would be nice to get it onto the new drive.
Is there any way I can do this?
- Accedi per poter commentare
Try doing a restore of just the recovery partition. Since the partition is no longer on the target drive, that space should show up as unallocated space in ATI. Do the restore to there and see if it works.
IF the partition is still there, you can restore to that partition -- it will probably be the only one highlighted when you are given the screen to select a target location. but just be sure you don't pick the "C" partition ;)
- Accedi per poter commentare